Colour And Lighting Settings - Nokia N78 Manual Del Usuario

Show captured image
●
the captured image after it is taken or to continue
image capturing immediately.
Default image name
●
for the captured images.
Extended digital zoom
●
the zoom increments to be smooth and continuous
between digital and extended digital zoom,
(paused) allows the zoom increments to pause at
the digital and extended digital step point, and
allows a limited amount of zoom while retaining the
image resolution. Use the extended zoom only
when getting closer to the subject is more
important than the final image quality. The overall
quality of a digitally zoomed image is always lower
than that of an unzoomed image.
Capture tone — Set the tone that sounds when you
●
capture an image.
Memory in use
●
images.
Rotate image
●
that are captured when the device is held upright to
be rotated when you open them in Gallery.
Restore camera settings
●
settings to default values.

Colour and lighting settings

In the active toolbar, select from the following:
68
— Select whether to view
— Define the default name
— On (continuous)
— Select where to store your
— Select whether you want images
— Restore the camera
Flash mode
●
flash mode.
Colour tone
●
White balance
●
condition. This allows the camera to reproduce
allows
colours more accurately.
Exposure compensation
●
On
are shooting a dark subject against a very light
background, such as snow, adjust the exposure to
Off
+1 or +2 to compensate for the background
brightness. For light subjects against a dark
background, use -1 or -2.
Sharpness
●
sharpness of the image.
Contrast ( ) (image only) — Adjust the difference
●
between the lightest and darkest parts of the image.
Light sensitivity
●
light sensitivity in low light conditions to avoid too
dark images.
The screen display changes to match the settings you
make.
The available settings vary depending on the selected
camera.
The setup settings are shooting-mode specific.
Switching between the modes does not reset the
defined settings.
The setup settings return to the default settings when
you close the camera.
( ) (image only) — Select the desired
( ) — Select a colour effect.
( ) — Select the current lighting
( ) (image only) — If you
( ) (image only) — Adjust the
( ) (image only) — Increase the