Idiomas disponibles
Idiomas disponibles
X10 HOME ENTERTAINMENT
Installing the system
1. Plug the PowerMid Transmitter (ST10) into a 230V~ outlet in
the room where you want to use your remote control (up to 20
feet/6 meters away from where you normally sit).
Make sure the front of the unit (with PowerMid name) is facing
you. Fully extend the antenna.
2. Plug the PowerMid Receiver (RE10) into a 230V~ outlet in
the room where your TV, VCR, Stereo, etc. is located (up to 20
feet/6 meters from it). Point the front of the Receiver towards
the TV, VCR, stereo etc. Fully extend the antenna.
3. Point your remote control at the Transmitter. It receives the
signals and transmits them to the Receiver. The Receiver then
re-transmits these infrared signals to your TV, VCR, stereo, etc.
Expanding the system
-Add more Transmitters to use your remote controls in several
rooms.
-Add more Receivers to control equipment in different rooms.
-Add an Infrared Extender (sold separately) if you need to place
the PowerMid Receiver next to your equipment instead of in
front of it, or if your equipment is located inside a closed
cabinet.
Troubles shooting
Note: The Transmitter and Receiver will most likely be in
different rooms (up to 30 meters away). Range depends on:
1. The number of floors and walls the signal has to travel
through and material these walls and floors are made of.
2. Other 433MHz sources (e.g. wireless head phones, wireless
speakers) can effect the range . The best range will be
achieved when these sources are switched off while using the
PowerMid. Cordless phones will not affect the PowerMid.
3. Some satellite receivers require more careful positioning of
the PowerMid system. If any difficulty is encountered, try to
move the PowerMid (Receiver) a little to various positions until it
operates correctly.
P/N 33000H13069B
4
BMB HOME Rev. 01-03-06
