Tabla de contenido
R&S ETC
2.1.1
On/Standby Key
See (3) in
Fig.
2-1.
The on/standby key works only if the AC power switch on the back of the R&S ETC is
switched on. The on/standby key switches the R&S ETC from stand-by to on and back.
For further information see chapter 4.1.
2.1.2
Hardkeys
See (1) in
Fig.
2-1.
For detailed information see the user manual.
Hardkey
Description
PRESET
Sets a defined instrument state.
SAVE/RCL
To store and load measurement results and settings.
SETUP
To perform basic instrument configurations.
HCOPY
To customize the printout. To select and configure the printer.
MODE
To select between measurement modes.
FREQ
Sets the frequency for the frequency range under consideration.
SPAN
Sets the frequency span to be analyzed.
AMPT
Sets the reference level, the RF attenuation/preselection and the unit for the level
display. To select transducer factors.
BW
Sets the resolution bandwidth, video bandwidth and channel bandwidth.
SWEEP
Sets the sweep time and the trigger. To select continuous measurement or single
measurement.
MEAS
To perform measurements.
TRACE
To configure the measured data acquisition and the analysis of the measurement data.
LINES
Configures display lines and limit lines.
MKR
Sets the absolute and relative measurement markers (markers and delta markers).
MKR->
Positions the absolute and relative measurement markers (markers and delta markers).
Getting Started 2116.7884.02 - 04.00
Interfaces and Connectors
15
Tabla de contenido
