Controls; Other Features - GE ADHB35 El Manual Del Propietario

Controls

Appearance may vary by model.
indicator
High, Medium
light
indicator light
Controls
NOTE: When the bucket is full or removed, the controls cannot be set.
1. Power Pad
2. Fan Speed Pad
Controls the fan speed.
speed.
Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
Smart Dry compares the set humidity level with the actual
humidity and adjusts the fan speed automatically. 3. Display
Shows the set % humidity level while setting, then shows the
actual (+/– 5% accuracy) room % humidity level.
4. Humidity Set Control Pads
for continuous operation, press the – pad until the screen reads
NOTE:
operate continuously at its maximum dehumidification settings
if attached to a hose to drain or until the bucket is full.
value (%).
percent value (%).
When you first use the dehumidifier, set the humidity control
to achieve the humidity level. If you still have damper air than
desired, set the humidity level to a lower setting or select

Other Features

Alarm
seconds to remind you to empty and replace the bucket.
Power Outage
In the case of a power outage or interruption, the unit will automatically
restart, in the settings last used, after the power is restored.
– pad and set to a lower percent
+ pad and set to a higher
Delay On/Off
indicator lights
indicator light
5. Filter Timer
will glow to remind you to clean the filter. Remove the filter and
clean it.
reminder. See the Care and Cleaning section.
6. Delay Off
While the dehumidifier is operating press the Delay button.
of hours you want the dehumidifier to continue to operate
before turning Off.
NOTE: After displaying the time, the Display will revert to
showing the current humidity after 5 seconds have passed.
on the delay.
Delay On
While the dehumidifier is off press the Delay button.
of hours you want the dehumidifier to remain off before turning
On.
NOTE:
unit turns on.
To cancel the Delay:
Delay will be cancelled.
7. Empty Indicator
emptied, or when the bucket is removed and/or not replaced in
the proper position.
Auto Shut Off
the bucket is full, or when the bucket is removed or not replaced in
the proper position. NOTE:
3 minutes after bucket is removed.
Auto Defrost
When frost builds up on the evaporator coils, the compressor will
cycle off and the fan will continue to run until the frost disappears.
bucket needs to be
emptied or is not in place
in the unit
49-5000443 Rev. 1