Warm Start - Craftsman 536.887752 El Manual Del Propietario

Recoil Starter Handle
4. Move throttle control to "FAST'
position. Operate the engine with
the throttle control in the "FAST"
position (see Figure 23).
Throttle Control
Figure 23
5. Remove the ON/OFF keys from the
plastic bag. Insert one of the
ON/OFF keys into the key slot (see
Figure 24). Make sure the key
snaps into place. Do not turn the
ON/OFF key. Keep the second ON/
OFF key in a safe place.
f ( _ ON / OFF Key
Figure24
6. (RECOIL START) Rapidly pull the
starter handle (see Figure 25). Do
not allow the recoil starter handle
to snap back, but allow it to rewind
slowly while keeping a firm hold on
the starter handle.
F-031027L
gure 25
7. (ELECTRIC START) Connect the
power cord to the engine and de-
press the starter button.
Connect Jq
Power Cord /
Starter Button
17
Figure 26
8. AS the engine warms up, move
choke lever to "1/2 choke" position.
When engine runs smoothly, move
choke lever to "No Choke" Posi-
tion.
9. Run engine at full throttle "FAST"
when throwing snow.
Allow the engine to warm up for several
minutes before blowing snow in temper-
atures below 0°E
WARM START
If restarting a warm engine after a short
shutdown, leave choke at "OFF" and do
not push the primer button. If the en-
gine fails to start, follow the Cold Start
instructions.
FROZEN STARTER
If the starter is frozen and will not turn
engine:
1. Pull as much rope out of the starter
as possible.
2. Release the starter handle and let it
snap back against the starter. Re-
peat until the engine starts.