How To Enter A Program - Kinetec CPM concept Manual De Empleo

Beginning
To switch off the unit
Press the two keys at the same time and switch the
unit ON
Then
To change the program if necessary
To choose the treatment mode
To display the extension or flexion limit of the
movement
To change the limit of movement if necessary
To validate the new value, press another key
or wait more than 3 seconds
To record the program 10
Then
OR
To cancel the program
To exit program mode, switch OFF and switch ON
the unit.
Comments:
• The values shown in the 'Display' column are examples.
Keys to press
ELBOW MODULE 1.0
Program
Program
Or
Program
10
Or
Program
10
Program
10
Program
Or
20 Ext/Flex
Program
-20 Ext/Flex
or
Program
SPEEd:
Load : _ _ _ _ _ _
Pause low
Program
Save:+
Program
Program
Program
Program
ELBOW MODULE 01.0
Display
KINETEC
Welcome text during 3 seconds
2
The program number blinks.
EMPTY
10
The new program number blinks.
EMPTY
10
ext/Flex 90
The display shows the new movement
selected.
10
After the selection of the movement press
warm up 90
the Warm Up key to validate it.
10
Ext/Flex 90
10
The value blinks.
120
10
120
The new value blinks.
10
While the value blinks press
2
the
to change if necessary.
No timer
0
10
clear:-
10
The program 10 has been recorded and the
Saving
display indicates the next program so you
can change another program.
11
EMPTY
10
The program 10 has been cancelled and
clearing
the display indicates the next program so
11
you can change another program.
EMPTY
KINETEC
To use the modified program see page 10.
Use of the hand control

How to enter a PROGRAM ?

Remarks
or key
9
GB