Troubleshooting; General Troubleshooting - Weber Summit Guia Del Propietario

TROUBLESHOOTING

GENERAL TROUBLESHOOTING

Problems
Burner does not ignite when you push in and
turn the burner control knob.
Burner does not ignite, or flame is low.
Burner flame pattern is erratic.
Burner burns with a yellow or orange flame,
in conjunction with the smell of gas.
Inside of lid appears to be "peeling."
(Resembles paint peeling.)
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information
on our website. Log onto www.weber.com.
© 2016 Weber-Stephen Products LLC. Weber, the kettle silhouette, the kettle configuration, Summit and www.weber.com are registered U.S. trademarks; GBS, Rapidfire, Char-Baskets,
One-Touch Cleaning System, Snap-Jet and Gourmet BBQ System are trademarks; all of Weber-Stephen Products LLC, 1415 S. Roselle Road, Palatine, Illinois 60067 USA.
32
Solutions
Be sure that there is gas flow to the burner by attempting to match light your burner. Refer to "BURNER
IGNITION - Lighting with a Match." If match lighting is successful, the problem lies in the ignition
system. Refer to "SNAP-JET GAS IGNITION SYSTEM MAINTENANCE."
™
Be sure that wires are correctly inserted into terminals. Check that the black wire is connected to the
red terminal on the valve. Check that the white wire is connected to the ground terminal at screw. Refer
to "SNAP-JET GAS IGNITION SYSTEM MAINTENANCE."
™
LP fuel could be low or empty. Replace LP cylinder. Refer to "REMOVING THE LP CYLINDER."
Inspect burner tube for possible obstructions. Refer to "ANNUAL MAINTENANCE."
The inside of the lid is aluminum. It is not painted. It cannot "peel." What you are seeing is baked-on
grease that has turned to carbon and is flaking off. THIS IS NOT A DEFECT. Clean thoroughly. Refer to
"CLEANING THE INSIDE OF THE GRILL."
WEBER-STEPHEN PRODUCTS LLC
www.weber.com