Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Use a connecting cable type H07 of a suitable section for the consumed
intensity by the pump motor.
• Before connecting the motor, check the necessary protection type.
• Adjust the correct thermical value according to the needs of each pump.
• Verify the right connection of the ground cable to the installation.
• It is very important to keep to the installation and electrical connection con-
ditions. Should they not be heeded, the pump manufacturer does not accept
any responsibility and considers the guarantee void.
• The motors are subject to EEC regulations with IP-55 protection.
• Special installation regulations may exist.
• The mains cable can only be connected by specialised and authorised tech-
nicians.
• Incorrect mains connection could result in death.
4. START-UP INSTRUCTIONS
QUESTIONS PRIOR TO START-UP
• Before starting up the pump, the following operations must be done:
a- If the pump comes with pre-
filter:
1. Open the prefilter cover
(Fig. 4)
2. Fill the pump with water,
through the prefilter, till the
water overflows from the
suction outlet.
3. If, during these operations
the prefilter basket was
removed, do not forget to
replace it inside the pre-
filter.
b- If the pump comes without
prefilter, fill the pump with
the water from the installa-
tion.
c- Check that the tension and
power of the supply corre-
spond to those determined
in the features plate of the
pump..
22
Tabla de contenido
