Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• The operating safety of the machine is only guaranteed with the compliance
and respect for that mentioned in the installation and service instructions.
• The value limits stated in the table of technical specifications must under no
circumstances be exceeded.
• In the case of defective operation or breakdown, contact the nearest manu-
facturer's agent or the manufacturer's Technical Customer Service.
INSTALLATION AND ASSEMBLY WORK WARNINGS
• While connecting electrical cables to the machine's motor, take care of the
mechanism inside the connection box, check that no pieces of cable remain
inside after closure and that the earth contact is correctly connected. Connect
the motor using the electrical diagram attached to the machine.
• Check that the electrical cable connections to the machine's terminal box are
well set and firmly attached to the connection terminals.
• The pump electrical installation should have a differential the value of which
is not greater than 30mA.
·• Check that the terminal box joint is used correctly, thus preventing water from
entering the terminal box of the electric motor. Likewise, check that the pack-
ing gland has been placed and pressed correctly inside the joint.
• The pumps must be installed on a flat and solid surface, at a distance of min-
imum 3,5 meters from the pool (according to regulation NF C 15-100 or ana-
logue, valid in each region or country).
• They must be fixed in a horizontal position. These pumps are not self-priming
and they should be installed below water level. The suction pipe should be as
short as possible in order to reduce the suction time. The place where the
pump is installed should be dry and aired at all times.
• Special attention should be paid to ensure that under no circumstances water
gets into the motor and the electric voltage parts.
• Should the envisaged use be different from that mentioned, adaptations and
supplementary technical regulations may be necessary.
STARTING-UP WARNING.
• Before starting the pump for the first time, verify the calibration of the motor
electric protection mechanisms and check that the protectors against elec-
trical and mechanical contacts are correctly positioned and well fixed.
• It is recommended not to use the pool during that first check of the pumping
equipment installation.
17
Tabla de contenido
