Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Your air conditioner is designed to install in standard double hung windows with opening widths of
23 to 36 inches(584mm to 914mm) (See Fig.1).
EX ERIOR
T
OFFSET
WALL
STOOL
SILL
INTERIOR
WALL
Mounting Hardware
3 4 (or 1
2
)
Lock Frame
Screws
(2)
(7)
Top Rail Hardware
or
3 8 Screws
(4)
INSTALLATION INSTRUCTIONS
Lower sash must open sufficiently to allow a clear vertical
opening of 13 inches (330mm). Side louvers and the rear
of the AC must have clear air space to allow enough airflow
23 to 36
584mm to 914mm
through the condenser, for heat removal. The rear of the unit
13 min.
must be outdoors, not inside a building or garage.
(330 mm)
Fig.1
Sash Lock
(1)
Top Rail
(1)
NOTE:
Save
Carton
for future reference. The carton is the best way to store unit
during winter, or when not in use.
TOOLS NEEDED:
Phillips Screw Driver
Drill(If pilot holes are needed)
CAUTION:
When handling unit, be careful to avoid cuts from
sharp metal edges and aluminum fins on front and rear coils.
NOTE:
The top rail hardware and the following Fig.A,
Fig.B and Fig.C are not applicable to the units
than 10000Btu/h.
Before installing unit, the top rail must be assembled
on the unit (For <10000Btu/h models only).
Tool Needed: Phillips Screwdriver
A: Remove the air conditioner from the carton and place
on a flat surface.
B: Remove top rail from the bottom of the packaging
material as shown in Fig.A
10
and these
Installation Instructions
more
Capítulos
Tabla de contenido
Solución de problemas
