System Messages; E-Codes - Accu turn 1500 Manual Para El Operador

66
Trouble shooting
7.1 7.1

System messages.

System messages.
The wheel balancer can show messages to the The wheel balancer can show messages to the
operator. These may be error related (E-codes) or operator. These may be error related (E-codes) or
service related (C-codes). The codes will be described service related (C-codes). The codes will be described
in the following chapters. in the following chapters.
Whenever a code appears: Whenever a code appears:
-
-
write it down
write it down
- - look up the code in the list. If the code is not look up the code in the list. If the code is not
described, call ACCU Service. described, call Technical Service.
- - perform the steps described. perform the steps described.
The format of this chapter is: The format of this chapter is:
Code Code
Description Description
• Step(s) to be performed. • Step(s) to be performed.
7.1.1 7.1.1

E-codes.

E-codes.
When the E-code is displayed, a low beep is generated. When the E-code is displayed, a low beep is generated.
E22 E22
Spinning timeout. Spinning timeout.
E23 E23
Spinning speed not reached. Spinning speed not reached.
E24 E24
Spinning speed too low. Spinning speed too low.
The wheel has failed to be spun up to balancing speed The wheel has failed to be spun up to balancing speed
within the time limit set. within the time limit set.
• Check that the brake pedal or wheel is not blocked • Check that the brake pedal or wheel is not blocked
by accident. by accident.
• Check the power supply. • Check the power supply.
• Call Accu Service. • Call Technical Service.
E25 E25
Reverse error. Reverse error.
The shaft turned in the wrong direction at a given The shaft turned in the wrong direction at a given
speed. speed.
• Apply the brake. • Apply the brake.
• Call Accu Service. • Call Technical Service.
E26 E26
No acceleration. No acceleration.
Shaft acceleration was not detected. Shaft acceleration was not detected.
• Call Accu Service. • Call Technical Service.
E27 E27
Slip detected. Slip detected.
• The wheel slips on the shaft. Mount wheel properly • The wheel slips on the shaft. Mount wheel properly
insuring that sufficent torque is applied to wing nut. insuring that sufficent torque is applied to wing nut.
E28 E28
Speed limit reached. Speed limit reached.
• Call Technical Service. • Call Accu Service.
E29 E29
START pushbutton pressed with wheel guard raised. START pushbutton pressed with wheel guard raised.
E50
Operator's Manual ACCU 1500