Installation - Stile CF13650 Guia De Instalacion

INSTALLATION

ASSEMBLING THE FAN
 Remove the center nut from the motor assembly. Leave
the washer and stop nut on the shaft, and make sure the
stop nut is bottomed out on the shaft.
CENTER
NUT
STOP
NUT
 With the bossed side of the blade marked "This Side To
Hub" facing the motor assembly, slide the blade through
the outside of the motor housing and onto the blade
mount so the bosses fully seat in the blade mounting
holes.
BOSSED SIDE
MARKED "THIS
SIDE TO HUB"
WASHER
MOTOR
ASSEMBLY
BLADE
MOTOR
HOUSING
BLADE
MOUNT
7 - English
 Install the blade screws and tighten to secure the blade
in place.
BLADE SCREWS
BLADE
 Repeat the above steps to install the remaining two
blades.
 Install the LED light panel as shown, then replace the
center nut and tighten securely.
LIGHT
PANEL
CENTER
NUT