Questions And Answers; Recommended Batteries; Base Station Power Consumption; General Specifications - Gigaset A390 Manual Del Usuario

Specifications

Recommended batteries

Technology:
(NiMH)
Size:
Voltage:
Capacity:
We recommend the following types of bat-
tery:
◆
GP 550/700 mAh
◆
Yuasa Phone 700/800 mAh
◆
Peacebay 550/650 mAh
◆
Corun Ni-MH AAAJ650 (650 mAh)
◆
Highpower HFR-44AAAJ650 (650 mAh)
(Valid at the time of going to press)
The handset is supplied with recom-
mended batteries.

Base station power consumption

In standby mode
– Handset in base station
– Handset outside base station
During a call

General specifications

DECT standard
WDCT standard
Range
Operation time (DECT
version)
– Talk time
– Standby time
Operation time
(WDCT version)
– Talk time
– Standby time
Base station power
supply
Environmental con-
ditions in operation
*) country-specific
Nickel-metal-hydride
AAA (Micro, HR03)
1.2 V
650 mAh
approx. 1.3 W
approx. 0.8 W
approx. 1.0 W
*
is supported
*
is supported
up to 300 m outdoors 
up to 50 m indoors
up to 12 hours
up to 177hours
up to 6 hours
up to 144 hours
100/240 V~, 50 Hz
+5 °C to +45 °C, 20% to
75% relative humidity
16

Questions and answers

If you have any queries about the use of
your telephone, visit our website at 
www.gigaset.br 
for 24-hour support. The table below con-
tains a list of common problems and possi-
ble solutions.
Problem Cause
Nothing The hand-
appears in set is not
the display. switched
on.
The batter-
ies are flat.
No wireless The hand-
connection set is out-
to the base side the
station, range of
Base
flashe the base
s in the dis- station.
play. The hand-
set is not
registered.
The base
station is
not turned
on.
You cannot The phone
hear a cord sup-
ringer/dial- plied has
ling tone not been
from the used or
fixed line has been
network. replaced
by a new
cord with
the wrong
jack con-
nections.
Error tone The sys-
sounds after 
tem PIN
system PIN you have
prompt. entered is
incorrect.
PIN forgot-
ten.
Solution
a
Press the end call
key for approx.
5 seconds or place the
handset in the base
station.
Charge or replace the
batteries.
Move the handset
closer to the base
station.
¢
Register the handset
page 13.
Check the mains con-
¢
nector on the base sta-
tion page 5.
Please always use the
phone cord supplied or
ensure that the
pin connections are
correct when purchas-
ing from a retailer: 
3-4 assignment of
telephone leads/
EURO CTR37.
Reset the system PIN to
¢
the default 0000
page 15.
All handsets are 
de-registered. All set-
tings are reset. All lists
are deleted.