Craftsman CMXGIAC2200 Manual De Instrucciones página 10

DANGER: Explosion and Fire. Do not overfill fuel
tank. Fill to 1/2 inch from top of tank to allow
for fuel expansion. Overfilling may cause fuel
to spill onto engine causing fire or explosion
which will result in death or serious injury.
(000166b)
See
Fig. I
and
Fig.
J.
Fuel requirements are as follows:
• Clean, fresh, unleaded gasoline.
• Minimum rating of 87 octane/87 AKI (91 RON).
• Up to 10% ethanol (gasohol) is acceptable.
• DO NOT use E85.
• DO NOT use a gas oil mix.
• DO NOT modify engine to run on alternate fuels. Stabi-
lize fuel prior to storage.
1. Verify unit is OFF and cooled entirely prior to fueling.
2. Place unit on level ground in a well ventilated area.
WARNING: Explosion and Fire. Verify fuel cap
vent is set to ON for operation, and OFF for
transportation and storage. Failure to do so
could result in poor unit performance, death or
serious injury. (000362)
3. Clean area around fuel cap and turn vent on fuel cap
to ON.
Fig. I
4. Turn cap slowly to remove.
5. Slowly add recommended fuel. Do not overfill.
NOTE: Fill to red insert inside filler neck.
6. Install fuel cap.
7. Turn vent on fuel cap to OFF for transportation and
storage to avoid fuel spills.
Fig. J
NOTE: Allow spilled fuel to evaporate before starting unit.
8
IMPORTANT NOTE: It is important to prevent gum
deposits from forming in fuel system parts such as
the carburetor, fuel hose or tank during storage. Alco-
hol-blended fuels (called gasohol, ethanol or metha-
nol) can attract moisture, which leads to separation
and formation of acids during storage. Acidic gas can
damage the fuel system of an engine while in stor-
age. To avoid engine problems, the fuel system
should be emptied before storage of 30 days or lon-
ger. See the
buretor cleaner products in the fuel tank as
permanent damage may occur.
001112
002543
Storage section. Never use engine or car-
Owner's Manual for Portable Generator