JB Systems Light RF-DMX CONVERTER Manual De Instrucciones página 6

ENGLISH
MODE 1: WITH 1MSL, 2MSL, 3MSL or 4MSL setup
Used to control light effects using 1ch DMX mode or 1MSL or 2MSL or 3MSL or 4chMSL
configuration. You can control almost all JB SYSTEMS light effects and many LED lights from Briteq.
For example, the following products are controllable by the RF DMX converter:
LED Rainbow, LED Matrix, Andromeda DMX, Genius DMX,...
Simple setup:
Note: if you want to use the 1MSL or 4MSL setup, together with other DMX-effects, just use a mini DMX-
splitter! (see drawing below)
All these products should be compatible with the MODE1 of the RF-DMX converter.
Even if the connected units don't use 4DMX-channels, the RF-DMX RECEIVER will always send out 4
channels for each of the 4 groups. As a result, the connected units should be always setup with the following
start addresses:

Unit1: start address = 001

Unit2: start address = 005

Unit3: start address = 009

Unit4: start address = 013
Mode1 uses sticker M1 for the transmitter, the sticker layout has 4 groups.
1. Blackout button: This button set every units in blackout mode
2. Standby button: switches the CH1 between 000 and last setting before
standby.
3. DOWN button: allows the user to change the show of a specific group
4. UP button: allows the user to change the show of a specific group
Effects with simple DMX on/off: the units should be always setup with the
following start addresses:

Unit1: start address = 002

Unit2: start address = 006

Unit3: start address = 010

Unit4: start address = 014
The user can switch on/off the unit using the standby button.
Dipswitch settings: 1000
JB SYSTEMS
®
4/40
OPERATION MANUAL
RF-DMX CONVERTER
DMX-