Master / Slave Mode - Briteq Spectra 3D Laser Manual De Instrucciones

ENGLISH

#2 MASTER / SLAVE MODE:

You can connect several SPECTRA 3DLASERs together: just put the first unit of the chain in one of the
standalone effect modes (see #1Standalone)and all other units in "Slave mode" (display shows "SLA") to
make them all work in perfect sync!
The "slave" lasers follow the instructions given by the first Spectra 3D laser (master) in the chain.
Settings for the slave units:
 Connect the DMX input of the laser to the DMX output of the previous laser in the chain.
 Press the FUNC-button until the display shows "SLA"
 Press the ENTER-button to confirm your choice.
#3 DMX512 MODE:
The laser can be controlled by any standard DMX-controller in 3 different DMX-modes:
 1 CHANNEL MODE: for extremely easy setup and use! (display shows "1Ch")
 2 CHANNEL MODE: for extremely easy setup and use! (display shows "2Ch")
 19 CHANNEL MODE: for full control of all possibilities. (display shows "19h")
 Connect the DMX input of the laser to the DMX output of the previous unit in the chain or directly to the
DMX-output of your controller.
 Press the FUNC-button until the display shows: "1Ch", "2Ch" or "19h".
 Press the UP/DOWN buttons to select the DMX-mode. (1Ch, 2Ch or 19ch)
 Press the ENTER-button to confirm your choice.
 Press the FUNC-button: the 3 digit number on the display starts blinking.
 Press the UP/DOWN buttons to select the DMX-address
 Press the ENTER-button to confirm your choice.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to "daisy chain" your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of the
light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the end of
the chain. Never use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
BRITEQ
®
7/68
USER MANUAL
SPECTRA 3D LASER