Craftsman 358.350590 Manual De Instrucciones página 20

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
TABLE
_1_ WARNING:
Always stop unit and disconnect
spark plug before perform-
ing all of the recommended
remedies below except remedies
that require
TROUBLE
REMEDY
1. Move ON/STOP switch to ON.
Engine
will not
start or will run
only a few
seconds
after
starting.
Engine will
not idle
properly.
Engine will not
accelerate,
lacks power,
or dies under
a load.
Engine
smokes
excessively.
Engine
runs
hot.
operation
of the unit.
CAUSE
1. ON/STOP switch in
STOP position.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
carburetol:
6. Carburetor
requires
adjustment.
7. None of the above.
1. Idle speed set too high
or too low.
2. Low Speed Mixture
requires
adjustment.
3. Crankshaft
seals worn.
4. Compression
low.
5. None of the above.
1. Air filter dirty.
2. Spark plug fouled.
3. Carburetor
requires
adjustment.
4. Exhaust
ports or muf-
fler outlets
plugged.
5. Compression
low.
6. Chain brake engaged.
7. None of the above.
1. Choke partially
on.
2. Fuel mixture
incorrect.
3. Airfilter diRy.
4. High Speed Mixture
requires a_ustment.
5. Crankcaseleak.
1. Fuel mixture
incorrect.
2. Spark plug incorrect.
3. High Speed Mixture
set too lean.
4. Exhaust
ports or muf-
fler outlets
ptugged.
5. Carbon
build-up
on
spark arresting
screen.
6. Starter housing dirty
7. None of the above.
2. See "Difficult
Starting"
in the
Operation
Section.
3. Fill tank with correct fuel mixture.
4. Install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel tine;
repair or replace.
6. See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
7. Contact
Sears Service.
1. See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
2. See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
3. Contact
Sears Service.
4. Contact
Sears Service.
5. Contact
Sears Service.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. See "Carburetor Adjustment" in the
Service and Adjustments Section.
4. Contact Sears Service.
5. Contact
Sears Service.
6. Disengage
chain brake.
7. Contact
Sears Service.
1. Adjust choke.
2. Empty fuel tank and refill with
correct fuet mixture.
3. Clean or replace
air filter.
4. See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
5. Contact
Sears Service.
I. See "Fueling Engine"
in the Operation
section.
2. Replace
with correct
plug.
3. See "Carburetor
Adjustment"
in the
Service
and Adjustments
Section.
4. Contact
Sears Service.
5. Clean spark arresting
screen.
6. Clean starter housing
area.
7. Contact
Sears Service.
20
Tabla de contenido
loading

Tabla de contenido