Mounting The Abidot; Adjusting The Stick-Out - Abicor Binzel ABIDOT Instructivo De Servicio

ABIDOT

6.2 Mounting the ABIDOT

6.2.1 Adjusting the stick-out

1
6
5
1 Hexagon socket screw M3x4
type:
2 Torch adaptor
Fig. 5 Adjusting the stick-out
NOTICE
• Before mounting the ABIDOT, you must mount the corresponding
welding torch on the robot and adjust the desired stick-out at the
ABIDOT. Make sure to use the suitable torch adaptor.
3 Torch adaptor type: W500,
A360, A500 455D TS, 505, VTS500
4 Torch adaptor type: W600,
650TS, 652D TS
1 Loosen the hexagon socket screw (1), but do not remove it.
NOTICE
• The torch adaptor to be used depends on the corresponding welding
torch type.
2 Mount the appropriate torch adaptor (2), (3) or (4) in the ABIDOT (5) by
slightly lifting the (6) clamping piece.
3 Adjust the stick-out by means of the corresponding torch adaptor.
Slide in the torch adaptor over the locking until the desired setting is
reached.
 Fig. 6 Details torch adaptor on page EN-12 and Fig. 7 Setting in torch
adapter on page EN-12
6 Putting into operation
2
3
4
5 ABIDOT
6 Clamping piece
EN - 11