Unpacking The Refrigerator; Choosing The Proper Location; Flooring; Ambient Temperature - LG LSXC22486 Serie Manual Del Usuario

Unpacking the Refrigerator

WARNING
Use two or more people to move and
install the refrigerator. Failure to do so
can result in back or other injury.
Therefrigerator is heavy. When moving
the refrigerator for cleaning or service,
the refrigerator straight out when moving
it. Do not wiggle or walk the refrigerator
when trying to move it, as
damage could occur.
such as gasoline, away from the
refrigerator. Failure to do so can result
Remove tape and any temporary labels from
the refrigerator before using. Do not remove
any warning-type labels, or the model and serial
number label.
To remove any remaining tape or glue, rub
the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing
a small amount of liquid dish soap over the
adhesiv
water and dry.
Do not use sharp instruments, rubbing alcohol,
tape or glue. These products can damage the
surface of the refrigerator.
Refrigerator shelves are installed in the shiping
position. Please reinstall shelves according to
your individual storage needs.

Choosing the Proper Location

Select a place where a water supply can
be easily connected for the automatic
icemaker.
NOTE
The water pressure must be between 20
and 120 psi (138 and 827 kPa) on models
without a water
120 psi (276 and 827 kPa) on models with a
water lter.
Wipe with warm
cleaners to remove
The refrigerator should always be plugged
into its own individual properly grounded
electrical outlet.
This provides the best performance and
also prevents overloading house wiring
from overheated wires. It is recommended
that a separate circuit serving only this
appliance be provided.
WARNING
To reduce the risk of electric shock, do not
install the refrigerator in a wet or damp area.

Flooring

To avoid noise and vibration, the unit must be
leveled and installed on a solidly constructed
compensate for une
front should be slightly higher than the rear to
aid in door closing. Leveling legs can be turned
easily by tipping the cabinet slightly. Turn the
leveling legs to the left to raise the unit or to
the right to lower it. (See Leveling and Door
Alignment.)
NOTE
Installing on carpeting, soft tile surfaces, a
platform or weakly supported structure is
not recommended.

Ambient Temperature

Install this appliance in an area where the
temperature is between 55°F (13°C) and 110°F
(43°C). If the temperature around the appli-
ance is too low or high, cooling ability may be
adv ected.

Replacing LED lighting

The refrigerator compartment lamp is a LED
interior lighting, so maintenance must be

Measuring Dimensions and Clearances

Too small of a distance from adjacent items may
result in lowered freezing capability and increased electricity consumption charges.
Allow at least 24 inches (61cm) in front of the
refrigerator to open the doors, and at least 2in.
(5.08) between the back of the refrigerator wall.
INSTALLATION 11
eveling legs to
r. The