Juiceman JM1000M Manual Del Usuario página 11

• Once the workbowl lid has been removed from the workbowl place it upside
down to hold the chopping blade and keep your counters clean.
• Although plastic parts of the workbowl are dishwasher-safe, you may wish to
wash them by hand to retain their clear appearance.
• When making bread crumbs, chopping nuts or grinding coffee beans make
sure workbowl is completely dry.
• For grinding coffee beans and nuts, use the flat blade and place up to 2 cups
(about 5 oz.) of coffee beans or 1 cup (about 4 oz.) of nuts into the workbowl.
Press the High button; allow the appliance to run until the desired grind is
achieved.
• When chopping dried fruits, add a little flour to keep the pieces from sticking
together.
• Do not use the workbowl to:
o Grind bones, grains or hard spices
o Liquefy fruits and vegetables
Care and Cleaning
This product contains no user serviceable parts. Refer service to qualified service
personnel.
Important: Always unplug your appliance from the outlet before cleaning.
CLEANING
1. Unplug your Juiceman ® Express Jr. and disassemble.
2. Using a sponge or damp cloth, clean the motor base and rubber feet.
Important: Do not immerse the base in water or spray with water. Clean only by
wiping with a damp sponge, cloth or paper towel.
3. All parts – except the motor base – are dishwasher-safe (top-rack only) or you
may wash in warm, soapy water, using any mild liquid dishwashing detergent.
Do not use any products containing ammonia or scouring powders, as these
can dull, scratch or mar the surface. Use the cleaning brush provided to
remove pulp left on any of the removable parts. Do not use metal brushes or
pads.
REMOVING TOUGH STAINS
1. Due to powerful staining properties of carotenoids found in many vegetables,
particularly carrots, we suggest soaking any stained parts overnight in one of
the following solutions:
• Biodegradable soap in enough warm water to cover workbowl parts
• ¼ cup bleach added to a sink full of warm water
• 1 part warm water to 1 part cider vinegar
• ½ small box of baking soda in enough warm water to cover workbowl parts.
Important: Never use ammonia or abrasive cleansers!
2. After soaking overnight, lightly scrub with soft bristle brush and liquid
detergent.
STORAGE
Store your appliance in a clean, dry place. Never wrap cord tightly around the
appliance. Do not put any stress on cord where it enters the motor base, as this
could cause cord to fray and break.
20
TROUBLESHOOTING FOR THE WORKBOWL
PROBLEM POSSIBLE CAUSE
Food is unevenly • Workbowl is over
chopped. filled.
• You may be running
the bowl continuously
instead of using
the Perfect Prep™
function.
• Food may be cut in
random sizes.
Appliance stops • Motor may be
running. overheating.
• Pieces of food in the
workbowl are too
large.
OVERHEAT PROTECTION SYSTEM
Important: This appliance contains a PTC overheat protection system. When
the appliance is being operated for too long or with too much load, the PTC
protector will shut down the power of the appliance to protect the unit. If the
power shuts down, unplug for 20 minutes and plug in for normal operation.
SOLUTION
• Smaller amounts will
process more evenly.
• Use the Perfect Prep™
button in 5 second
or less increments.
Allow the blades to
stop completely before
pressing the Perfect
Prep™ button again.
• Cut food in same size
pieces before placing in
processor.
• Unplug appliance
and allow it to cool
approximately 5 minutes
before continuing use.
• Cut food into ½-inch
pieces.
21