Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: Do not attempt to charge Jabra BT250v with anything other than the AC
adaptor provided. Using another AC adaptor may damage or destroy the headset.
IMPORTANT: The blue indicator light will be on while charging and will turn off
when charging is complete. Removing the headset from the charging cradle while it's
charging will put the headset into standby mode and stop the charging sequence.
IMPORTANT: Jabra BT250v cannot be used while charging.
3
Read the glossary
Read the glossary at the end of this document to familiarize yourself with important
terms used in this User Manual.
Once Jabra BT250v is fully charged, continue with these instructions.
4
"Pair" to your Bluetooth phone
Pairing³ will create a unique and encrypted wireless link between two Bluetooth
enabled devices such as your Bluetooth phone and Jabra BT250v.
1. Ensure the headset is off (see Turning headset on/off
section).
2. Press and hold until you see a solid blue light
(approximately 8 seconds), then release* (see Fig. 2).
3. Set your Bluetooth phone to "discover" the headset
by following your phone's instruction guide. Typically,
the steps involve going to a "setup, " "connect, " or
"Bluetooth" menu on your phone and then selecting
the option to "discover" a Bluetooth device.
4. Your phone will find the "Jabra BT250v" headset and
ask if you want to pair with it. Confirm this by pressing
"yes" or "ok. "
5. Enter passkey or PIN⁴ = 0000 (4 zeros), then press "yes" or "ok. "
IMPORTANT: If pairing was successful, the blue indicator light will briefly flash rapidly
before going back to flashing every 3 seconds. If unsuccessful, the light remains solid,
and you'll need to reattempt pairing (see steps 3–5 above).
4
* If you have a Bluetooth phone that supports the hands-free Bluetooth profile,
see Enhanced features section for alternative pairing instructions. Phone-
specific pairing instructions can be found online at www.jabra.com
5
Turning on/off call alert vibrate
The Jabra BT250v has a unique call alert feature that vibrates to inform you that you are
receiving a call. The vibrate function is enabled when you first turn on Jabra BT250v.
If you turn on the device in the usual way without touching the volume button, the
vibrate function will remain enabled.
1. To turn off the vibrate, hold the volume down button while you turn the headset on.
2. If you wish to re-activate the vibrate, hold the volume up button while you turn the
headset on.
BASIC OPERATIONS
6
Turning headset on/off
Turning
headset on
Fig. 2
Turning
headset off
Fig. 3
What you do
What you hear
Press and hold
for 3 to
Ascending
5 seconds until you see a
(low-to-high)
burst of flashes on the blue
tones
indicator light, then release
Press and hold
for 3 to
Descending
5 seconds until you see a
(high-to-low)
burst of flashes on the blue
tones
indicator light, then release
What you see
The blue indicator
light will flash while
the power is on (see
Status indicators table
below)
The blue indicator light
will stop flashing
5
Capítulos
Tabla de contenido
