Teka HLB Guía De Uso página 34

Switching on and setting the time
When plugging the oven in for the first time,
the logo will appear followed by 12:00 flashing
on the screen.
You must set the time in order to use the oven.
To do this select the hour with the left control
and the minutes with the right one.
Confirm the settings by pressing the
or waiting a few seconds.
An audible signal will be heard confirming that
the time has been set on the screen.
To change the time:
With the oven in standby (start screen), hold
the button until the time begins to flash.
Follow these steps to change the time:
WARNING
The sensitivity of the touch controls
continuously adapt
conditions. Make sure the glass surface of
the control panel is clean and free of any
obstacles when plugging in the oven.
If the clock does not respond correctly
when you touch the glass, unplug the oven
for a few seconds and then plug it in again.
Doing this causes the sensors to adjust
automatically and they will react again to
finger touch.
34
User's Guide
button
to the ambient
DEMO MODE (Special function
for shop floors)
With the DEMO mode activated, you can
control the oven without heating.
Activating this mode is recommended if the
oven is to be plugged in at a showroom.
Activating DEMO mode
Before setting the clock, press the buttons
simultaneously until "DEMO Mode ON"
appears on the screen.
Then, set the time on the oven.
The word "DEMO" will be shown permanently
on the panel and the oven will work as normal,
but without heating up.
To deactivate DEMO mode, unplug the oven
from the socket.
WARNING
In the event of a power failure, your
electronic clock/timer settings will be erased.
The time12:00 will appear.
You can set the time as described above.
If the oven door was locked before the
power cut, the locked symbol will appear
until it is unlocked.
This may take several minutes, depending
on the temperature inside the oven, and
during this period you cannot reset the time.
Once the door is unlocked, you can set the
time as described above.