Heat exchanger tubes.
Top plate of the fireplace.
5.2.
Ash in the fireplace.
When opening the door, you reach the burn pot where combustion takes place; hoover it and remove it
(make sure you'll put it back properly) in order to clean all holes; make sure they're clean and hoover the
support of the burn pot as well.
5.3.
Fireplace door.
Clean the glass with a towel, using a liquid for glass cleaning, always when cold.
The handle, though adjusted with an auto-blocking screw, should be revised periodically to be adjusted
whenever needed so as to remain tight.
5.4.
Security grill of the fireplace.
Simply brush the grill descaling the soot which may be adhered, using the cleaning brush sent in a cardboard
box inside the stove fireplace. The grill is fixed to the stove body, it cannot be removed.
5.5.
Ash box.
In models in this manual, you can access to the ash box by opening the door of the fireplace.
Ash box.
IMPORTANT: If the stove is operating while full of ash or residues, that might stretch the burn pot and its
support, the ash box and even the burn pot, being the cause of bad operation or possible breakdown, wouldn't be
under warranty.
This is necessary to ensure correct operation and maintain the stove's life duration. When winter ends,
contact your provider (if he did not contact you) and meet to carry out this maintenance; the following shall be done
(the stove must always be disconnected from power):
MAINTENANCE AT END OF SEASON OR EVERY 500 KG OF FUEL.
Drawing 11
30
Drawing 10
Drawing 12