Denver Electronics MC5220 Manual De Instrucciones página 6

ADJUST VOLUME
• Press VOL.+ button to increase the volume.
• Press VOL. – button to decrease the volume.
RADIO OPERATION
1. Press the STANDBY Button to switch on the unit.
2. Press the FUNCTION Button to the RADIO Function.
3. How to use the buttons for radio
i. Manual Tuning
Press the or
selected by pressing the
button
ii. Automatic Tuning
a) Press & hold the
b) When a station of sufficient strength has been found Tuning will stop or you can stop the
automatic tuning by pressing
4. To turn off the radio, Press the STANDBY button.
PRESET TUNING
1. Select your desired station according to the normal tuning procedure.
2. Press the MEMORY button on the remote, "P-01" will appear and flash on the display, Then
use M-UP or M-DN- button on the remote or press the M+ / M- button on the unit to change
the number where the station will be stored. (P01 to P20) to change the number where the
station will be stored. (P01 to P20)
3. Store the current frequency by pressing MEMORY button on the remote again when you get
the desired number.
4. Repeat the same procedure to set other desired frequencies into Memory No.1 to No.20
Note: The unit can be preset up to 20 stations.
MEMORY RECALL
Recall the stored frequencies by pressing M-UP or M-DN BUTTON on the unit, or press the M+ /
M- button on the unit to select 1 to 20 stations as desired
NOTE: As stored frequencies can only be stored for long time with the power supplying. The
station you stored will be lost and can not be recalled in case that you cut off the power.
HANDING A COMPACT DISC
• Always protect a disc against scratches, soil , dust and etc. If a disc is treated with
reasonable care, wiping off the disc with a soft cloth should be the only maintenance needed
to retain its excellent sound reproduction. Discs should be retained in their original case
during periods of non-use.
• Handle a disc only by its edges, Do not touch the surface or rainbow-colored side of the disc
• Handle a disc as shown in the illustrations in this section
• Use a soft cloth to wipe a disc clean. Do not use benzene, thinner, or other chemical cleaners
to clean the disc as damage may result. A disc should always be wiped in a straight line from
its center to its edge. Never wipe a disc in a circular motion.
• Do not expose a disc to direct sunlight, high humidity, or high temperatures for extended
periods of time. Do not place the Disc on other equipment or near any heat source.
• Dust on the pickup lens can lead to erratic operation and interruption of the sound during
play. To clean the pickup lens, open the disc compartment and blow the dust off . Using a
camera lens blower(available at most camera stores)
• Note: Do not touch the surface of the lens. Do not allow any liquids on the inside of the
product.
• To clean the CD player cabinet, use a soft and damp cloth to wire off the exterior surface.
button to search for desired frequency. Higher frequency can be
button while Lower frequency can be selected by pressing
or button until the display frequency starts run
or button.
ENG-6