SMART STOP: REBATE BOTTOM THICKNESS MEASURER
Switch the machine on by setting the main switch to ON.
G
0
If you are using the SMART STOP, the following warning message appears if the measurer
button is pressed:
-> In this case, you will need to remove any moulding and let the measurer position itself
against the fixed rule G. Now, still keeping the measurer button pressed down, touch the RESET
MEASURER screen key.
-> If you make a mistake (e.g. a moulding was still in place!), you can start the procedure again
via the MAINTENANCE menu.
Once the measurer origin is set, the execute screen will appear when the measurer button is
touched:
The moulding measurement will be displayed in the
key (032.1 for example).
MEASUREMENT
The measurement is validated by touching the
key and it will be used to com-
MEASUREMENT
pute the required position.