Cassese CS 969 Manual De Utilizacion Y Tecnico página 4

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

UNPACKING THE NUMERIC STOP (NS)
1
Open the crate and put the NS foot stand into an upright position.
With a 4mm hex head key, unscrew the 4 screws of the 2 foot stand locking
plates: P1 and P2 . Push P1 and P2 right back with a mallet, then slide them down
to the bottom of each foot. Retighten the 4 screws of plates P1 and P2.
With a 5mm hex head key, unscrew V1 and V2 and put the NS feet in the outside
position as shown in figures 3 and 4.
The NS can only be assembled after the CS 969 has been made level on the ground. The right-hand
extension and its support bracket have been dismantled and the 2 frame fastening screws are used.
THE FOLLOWING PROCEDURE REQUIRES AT LEAST TWO PEOPLE TO CARRY IT OUT
CUTTING
TABLE
E
Take the NS out of the crate and turn it over. Place the bed of the NS on bracket E, and screw them together
(10mm long tubular socket wrench + 5mm hex head key) without tightening, with the 2 screws, 2 washers and
2 nuts provided.
R1
Z
V1
2
ASSEMBLY OF THE NUMERIC STOP (NS)
3
2
Unlock locking screw Z and slide the guide GB of the NS
along screws 1-2-3 of the right-hand table and the nuts of
the 2 ruler supports R1 and R2. Screw 3 should be visible
in hole T3. Tighten screws 1, 2, 3 and V1 and V2 of ruler
supports R1 and R2 with a 4mm hex head key.
P1
P2
CUTTING
TABLE
T3
1
R2
GB
2
3
V1
4
E
1
V2
T3
V2
R2
Tabla de contenido
loading

Productos relacionados para Cassese CS 969

Tabla de contenido