Cassese CS 969 Manual De Utilizacion Y Tecnico página 5

GA
Z
TB
GA
TB
Lining up the stops:
Pass the thread under the head of the NS against the inner face of the guide
GB. Put in one screw and two nuts at one end of the thread (looped) and
hook to the left tip of the left extension stop.
Repeat for the other end of the thread. Adjust the length of the thread so as
to create tension when it is hooked to the right tip of the NS guide. Increase
the tension in the thread by tightening the nuts with a 10mm open end
wrench.
Proper adjustment:
1) The thread is stretched uniformly on the right and left stops.
2) There is no gap in the STOP/MACHINE joint (J).
If this is not the case, move the NS sideways until the thread is
fully stretched on the two stops and the gap in joint J disappears.
CS 969
GB
VB1
P R
GB
STOP
J
ADJUSTMENT OF THE NUMERIC STOP (NS)
Slide the NS head towards the cutting table and position plate
GA right next to screw VB1 (see fig 4: PR= reference posi-
tion).
Tighten screw VB1 with a 4mm hex head key.
Repeat for the following screw (VB2), and so on for the other
screws up to the end of the NS.
VB1
Fig 2
Left hand
extension
Perpendicular level (base)
Table
3
VB2
TB
V2
VB1
NS
fig 5
Horizontal
Stop
level
P R