Installation; Installing The Intercom Panel; Installing The Monitor; Wiring - Extel 720308 Instalación Y Guía Del Usuario

5. Light-up name holder (automatic name holder backlighting in response to light level). To change the label in the
name holder, carefully lift the plastic protector with a small screwdriver and slide out the label.
6. Microphone: allows the visitor to communicate with the person inside.
7. Screws for wall-mounting.
8. Camera lens adjustment holes.
9. Terminal to connect the wires from the monitor and the door openers.
10. Dawn-to-dusk cell (controls the IR lighting and the name holder lighting in the dark).
11. Sound adjustment screw.
12. Selector (do not modify the settings on this project - not valid on this model).

4. INSTALLATION

Note: If you test your product before installing it, put the monitor on a flat surface and make sure not to test it
with the intercom panel and the monitor in the same room. If you do so, the videophone will emit a piercing sound
(feedback effect).
a. Installing the intercom panel
1. Remove the screw under the intercom panel (1)
2. Tilt the intercom panel forwards (2)
3. The lens of the panel must be placed at a height around 1.60 m (3).
4. Firmly attach the weather-proof shield with screws (5) and apply a silicon seal* (4) between the shield and the
wall to prevent water from running between the two. * Do not use an acetic acid-based silicone (smells like
vinegar).
5. Connect the wires according to the wiring diagram (fig. 6).
6. Fit the intercom panel onto its weather-proof shield (7).
7. Re-install the attachment screw (8).
Important: Do not have the camera directly exposed to the sun or facing a reflective surface. At the
same time, remember to properly insert the intercom panel lug in the hole on the weather-proof shield.
Tip: it is recommended that the wires be passed through a sheath to protect them from impacts and weather.
b. Installing the monitor (
1. Attach the wall bracket (2) so that the screen of the monitor will be around 1.60 m high.
2. Connect the wires coming from the intercom panel (4).
3. Insert the adapter wires (3) in the back of the monitor (without plugging it into the wall socket).
Warning you must comply with the polarity (red and black terminals).
4. Install the monitor (1) on the wall bracket (2).
5. Plug the adapter into the 230V wall socket .

5. WIRING

In order to avoid the risks of interference and malfunction, do not pass the wire for your videophone through the
same sheath as the electrical wires.
Warning: Do not under any circumstances double wires to increase the wire size.
If there is a short circuit on the line, protection is triggered. Disconnect and reconnect the power supply after 10 s.
a. Connecting the videophone
Important:
All the maximum wire lengths shown in the table (fig. 6) must be observed at the same time.
EN3
(fig. 4)
fig. 5)
(fig. 6)
CFI EXTEL CONNECT - V1