Operating Advice (Pre Operation Checks); Ppe - Evolution S185 Instrucciones Originales

Fig. 13
Fig. 14
• Tighten the Bevel Locking Mechanism securely when the
desired bevel angle has been achieved by pushing the lever
downwards.
OPERATING ADVICE
(14)
(PRE OPERATION CHECKS)
Note: As all operating environments will be unique and diverse,
Evolution Power Tools offers the following general advice on
safe operational procedures and practices for the consideration
of the operator.
This advice cannot be exhaustive as Evolution has no influence
on the type of workshops or working environments in which
these machines may be used.
We recommend that the operator seeks advice from a
competent authority or the workshop supervisor if they are at
unsure of any aspect of using these machines.
It is important that routine safety checks are carried out (at each
time of usage) before the operator uses the machine.
WARNING: These pre-use safety checks should be carried out
with the machine disconnected from the mains power supply.
• Check that all safety guards are operating correctly, and that
all adjustment handles/screws are securely tightened.
• Check that the blade is secure and installed correctly. Also
check that it is the correct blade for the material being cut.
• Check the integrity of the power cord.
• Whenever possible clamp the workpiece to a rigid support
structure such as a workbench, saw horse or similar.
• The operator should always be aware of the position and
routing of the power cable.

PPE

(15)
• The operator should wear all relevant PPE (Personal
Protection Equipment) necessary for the task ahead.
This could include safety glasses,full face mask, dust masks,
safety shoes etc.
The Upper Blade Guard is specially shaped to deflect most of
the cut debris downwards and away from the operator. Such
debris may be hot and/or sharp. The operator should employ
due care when clearing such material from the workpiece after
a cut has been completed.
Note: Depending upon the material being cut some debris may
also lodge inside the blade guard. Any such material should
be removed during routine machine maintenance or during a
blade change.
16
www.evolutionpowertools.com