Cutting Depth Adjustment; Cutting Angle Adjustment - Evolution S185 Instrucciones Originales

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

www.evolutionpowertools.com
the Edge Guide with the arm passing through only one (1) of
the machined rectangular sole plate slots.
Adjust the edge guide so that it is at the required distance from
the blade and tighten the adjusting screw.
Check that the edge guide is parallel to the saw blade.

CUTTING DEPTH ADJUSTMENT

(12)
• Loosen the Depth Adjustment Locking Mechanism by pulling
the operating lever upwards. (Fig. 10)
• Adjust/re-position the sole plate to give the required cutting
depth (the amount by which the blade protrudes through
the sole plate).
Note: A depth scale can be found on the depth adjustment
quadrant, with a corresponding index mark incorporated into
the adjacent area of the machines upper blade guard. (Fig. 11)
Using these features can aid rapid setting.
Note: Although the depth scale and index mark are very useful,
enabling rapid depth setting, using them should always be
regarded as a guide to the setting achieved.
If a very precise depth of cut is required, then the blade setting
should be checked with an engineers precision ruler (not
supplied) or similar and adjusted accordingly.
• In most cases the cutting depth should be set at the
thickness of the material to be cut plus the depth of half of a
saw tooth (tip of the tooth to the tooth root). (Fig.12)
• Tighten the Depth Adjustment Locking Mechanism by
pushing the operating lever downwards to securely to lock in
the machine in the required position.
CUTTING ANGLE (BEVEL) ADJUSTMENT
(13)
Evolution steel cutting circular saws have the facility to tilt the
blade up to 45˚ to the left hand side. Bevel cuts are therefore
possible.
Note: The blade is at the vertical position when the protractor
scale reads 0˚.
Note: A protractor scale (0
- 45
0
Locking quadrant found at the front of the soleplate. Using this
will aid rapid bevel angle setting but should be regarded as a
guide only.
If a very precise bevel angle is required, then the blade setting
should be checked using a vernier angle gauge (not supplied)
and adjusted accordingly.
• Loosen the Bevel Locking Mechanism found at the front of
the machine, by pulling the lever upwards. (Fig. 13)
• Tilt the blade to the required angle as indicated on the
quadrant protractor scale. (Fig. 14)
) is incorporated on the Bevel
0
15
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Tabla de contenido
loading

Este manual también es adecuado para:

028-0001028-0002028-0003028-0004S185ccsl

Tabla de contenido