Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Axor Starck X 10205000 Modo De Empleo / Instrucciones De Montoje

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The shower system may only be used for bathing,
hygienic and body cleansing purposes.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
• Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 0,15 MPa.
• This mixer is equipped with a flush stream, which
enhances the natural side of the life element water.
As this flush stream does not contain any air, we
recommend the use of very deep basins to reduce
water spray.
• This mixer series is produced with the following spray
pattern - with the spray former with a waterfall. For an
alternative spray, an aerator with a round monospray,
that can changed easily on the spot, is enclosed. (see
page 34)
4
English

Technical Data

This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!

Symbol description

®
Assembly see page 31
Do not use silicone containing acetic acid!
Dimensions (see page 36)

Flow diagram

(see page 36)

with EcoSmart
®
 without EcoSmart
®
Spare parts (see page 38)
Special accessories (order as an
extra)
special tool #58085000
Installation putty
Operation (see page 35)
Hansgrohe recommends not to use as
drinking water the first half liter of water
drawn in the morning or after a prolonged
period of non-use.
Cleaning (see page 39) and
enclosed brochure
Test certificate (see page 40)
(flow
®
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 70°C / 4 min