Parts And Their Functions; Camera Unit - Panasonic GP-VD150E Manual De Instrucciones

Parts and their functions

 Camera unit
p
<Rear panel>
<Bottom panel>
1 Wireless remote controller signal light-sensing
area
Light sensors are located in two places at the front of the camera pedestal.
2 Status display lamp
This lights in the following way depending on the status of
the unit.
Orange: When the standby status is established
Green:
When the power is on
Red:
When trouble has occurred in the unit
Green and blinks twice:
When a signal matched by the remote control
ID has been received from the wireless
remote controller (optional accessory) while
the power is on
Orange and blinks twice:
When a signal which is not matched by the
remote control ID has been received from
the wireless remote controller (optional
accessory) while the power is on
3 Camera head
This rotates in the horizontal direction.
4 Lens unit
This rotates in the up and down direction.
5 IR ID switches [IRID]
[CAM1]
These are used to select the ID of the wireless remote
controller (optional accessory).
The IR ID switch settings "CAM1" to "CAM4" correspond
to the [CAM1] to [CAM4] buttons on the wireless remote
controller.
6 HDMI connector [HDMI]
This is the HDMI video output connector.
7 Anti-theft wire mounting hole
Use this hole to attach the wire bracket.
8 Service connector
This connector is used only when maintenance is carried
out.
9 DC IN connector [12V
Connect the AC adapter supplied with the unit to this
connector to supply the DC 12 V voltage to the unit.
13 (E)
[CAM2] [CAM3]
IN ]
[CAM4]