Electrical Connection; Energy Saving - Brandt BFL682ZNW Guía De Instalación Y Uso

Classe Temperature
SN from + 10°C to + 32°C
N from + 16°C to + 32°C
ST from + 16°C to + 38°C
T from + 16°C to + 43°C
Advice:
After installation of your appliance, set
its feet so that it is slightly tilted
backwards, it will facilitate the closing
of the door.
Before putting food, clean the interior
and exterior of your appliance with
bicarbonate of soda dissolved in water
(1 tablespoon of bicarbonate for 4
litres of water). Do not use alcohol,
abrasive powders or detergents which
could damage the surfaces. (See
chapter "Cleaning your appliance").

ELECTRICAL CONNECTION

The electrical installation must comply
with the applicable standards and
must be able to
maximum power indicated on the
rating plate.
The plug must be properly grounded.
We cannot be held responsible for any
incident caused by defective electrical
installation.
Electrical Installation Tips
• Do not use extension cable or
adapter or power strip.
• Never remove the grounding.
withstand the
7
• The socket must be easily accessible
but out of reach of children.
In case of doubt, ask to your installer.
Your device is compliant with EU
directives and their modifications.

ENERGY SAVING

To reduce the power consumption of
your appliance:
• Install it in a suitable location (see
"Installing your appliance").
• Keep doors open for as short time
as possible.
• Do not put hot food in your
refrigerator or freezer, particularly if
they are soups or preparations which
emit a large amount of steam.
• Ensure the optimal functioning of
your device by not letting accumulate
too much frost in the freezer (defrost
it when the ice thickness exceeds 5-6
mm) and periodically cleaning the
condenser (see "Maintenance your
device ").
• Regularly check the door seals and
make sure that they always close
effectively. If this is not the case,
please contact service after sales
service.
• Do not let it set at too low a
temperature.
• Not fulfilling with drawers, bins and
shelves arrangement could lead to
increased energy consumption.