Weight Limits - Ergomotion Contour Elite Gold Manual Del Usuario

safety precautions and usage statements
restarting.

WEIGHT LIMITS:

This product is not rated to support weights exceeding 850 pounds. This product
is not rated to support weights in excess of 850 pounds inclusive of the mattress
and bedding. The base will structurally support this weight, provided it is evenly
distributed across the bed base. The adjustable base is not designed to support
or lift this amount in the head or foot sections alone. Exceeding this weight
restriction could damage the bed and/or cause injury and will void the warranty.
IMPORTANT DO'S AND DON'TS
DO:
• Plug your adjustable base into a power surge protector.
• Evenly distribute weight when sleeping in a split setup. Uneven distribution
of weight can cause the base to raise unevenly.
• Call Customer Service for any technical issues. Do not try to force the base
down, this can damage the motors or frame.
• Use mild soap and water to clean your adjustable base if staining occurs.
• Keep in mind that adjustable bases are recommended to be used with
adjustable friendly mattresses
• Lower to the flat (horizontal) position after use and in between presets.
• Register your warranty as soon as your adjustable base has been delivered.
DON'T
• Sit on corners/edges of base, this may warp the frame, struts or foam.
• Tilt the base on its side. This can damage the legs and/or leg screws.
• Stand or jump on the adjustable base at any time, this can damage the
frame and motors.
• Drag the base to move it. Dragging the base could damage the frame, strip
the nut/bolts or break the legs. Purchase castors if you plan on moving your
base routinely.
• Enter and exit the adjustable base with the head and/or foot in the
articulated position. Enter or exit your adjustable in the flat (horizontal)
position.
4
• Tinker with or modify base. This will void the warranty.
• Press down on the head or foot while actuated can damage frame and
motors.
FCC Compliance:
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
To comply with the FCC RF exposure requirements, no
change to the antenna or the device is permitted. Any change
to the antenna or the device could result in the device
exceeding the RF exposure requirement and void user's right
to operate the device.
Radio Frequency: 2.4 GHz
SAVE THESE INSTRUCTIONS.