Códigos De Error De Auto-Chequeo - BECKWITH ELECTRIC M-3425A Libro De Instrucciones

C
Códigos de Error de Auto-Chequeo
1
2 Battery backed RAM test fail
3 EEPROM write power-up fail
4 EEPROM read back power-up fail
5 Dual port RAM test fail
6 EEPROM write calibration checksum fail
7 EEPROM write setpoint checksum fail
loss of power
8 EEPROM write setpoint checksum fail
loss of battery backed RAM
9 DMA checksum/physical block fail
10 Oscillograph Memory Test fail
11 DSP external program RAM fail
12 DSP A/D convert fail
13 DSP ground channel fail
14 DSP reference channel fail
15 DSP PGA gain fail
16 DSP DSP<-> HOST interrupt 1 fail
17 DSP DSP -> HOST interrupt 2 set fail
18 DSP DSP -> HOST interrupt 2 reset fail
19 DSP program load fail
20 DSP not running run mode code
21 DSP not running primary boot code
22 DSP DPRAM pattern test fail
23 EEPROM write verify error
26 WARNING calibration checksum mis-
match warning
27 WARNING setpoint checksum mismatch
warning
Tabla C-1 Códigos de Error de Auto-Chequeo
Códigos de Error de Auto-Chequeo Apendice – C
28 WARNING low battery (BBRAM) warning
29 Supply/mux PGA running test fail
30 External DSP RAM test fail
31 Unrecognized INT1 code
32 Values update watchdog fail
33 Abort Error
34 Restart Error
35 Interrupt Error
36 Trap Error
37 Calibration running check fail
38 Ethernet Board not running (Warning)
39 Not used
40 Interrupt noise INT2
41 Interrupt noise INT1
42 Not used
43 Not used
44 Oscillograph buffer overflow
45 Oscillograph buffer underflow
46 Failure of DSP to calculate calibration
phasors
47 Unable to calibrate input (gain)
48 Unable to calibrate input (phase)
49 Not used
50 Stack Overflow
51 Setpoint Write Overflow
52 Field Ground Error
C–1