Install The Hardware; Access The Product; Adjust Focus - Axis Q1635 Guia De Instalacion

SD Card Slot
Supports microSD cards with up to 64 GB of storage. For best recording performance, use
a microSDHC UHS-I or microSDXC UHS-I card. In temperatures below – 25° C use industrial
grade SD card.

Install the Hardware

NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.
1. Optionally connect external input/output devices, such as alarm devices. See on page 16
for information on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
- PoE (Power over Ethernet). PoE is automatically detected when the network
cable is connected.
- Connect an external power adapter to the power connector block. See
Connectors and Buttons on page 13.
5. Check that the indicator LEDs indicate the correct conditions. See the table on page
12 for more details. Note that the Status LED can be configured to be unlit during
normal operation.
6. Optionally insert a microSD card (not included) into the SD card slot.
NO TICE TICE
NO NO TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.

Access the Product

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/

Adjust Focus

To adjust the zoom and focus follow these instructions:
AXIS Q1635 Network Camera
19