Troubleshooting Guide - TaoTronics TT-AH025 Manual Del Usuario

TROUBLESHOOTING GUIDE

1. If the information listed in the troubleshooting guide can't solve your problem, please
email us for help.
2. Failure to keep this unit clean from mineral deposits may affect operation of this unit.
3. Customer failure to follow these instructions may void the warranty.
2
1
Problem Possible Cause
Unit not plugged in.
Failed to turn on the unit.
No power from power outlet.
No water in the water
reservoir.
Waterless indicator is
constantly on.
3 Water oater get stuck.
13
1. Spring
3
2. Rubber ring
3. Water oater
Solution
Ensure unit is properly
plugged in.
Try another power outlet.
Ensure the 1 spring is
secured properly to the tank
allowing water to pass
through to the base.
Adjust the 3 water oater to
a horizontal position and
make sure it can rise up with
water .
Not enough water inside the
tank.
Mist level is set too low.
The unit is on but
The base might be over lled.
no mist or little
mist is produced.
Mineral buildup on atomizer.
Tank may be damaged.
Tank cap is not tightened
securely.
2
Rubber ring was not
installed on tank cap.
Tank leakage.
1
Spring get stuck.
Mist level is set too high for
Mist height is low,
the room size.
damping surrounding
desk or oor.
Condensation
forms around
Air inlet is blocked.
humidi er or
on windows
and walls.
Low indoor temperature
leads to liquefaction.
Re ll and reinstall the water tank.
Adjust to larger mist output.
Remove the tank, empty the base and
place back the lled tank on the empty
base.
Put your hand towards the nozzle and
feel if there is air coming out. If yes,
clean the water scale on the atomizer
as instructed(p10).
Check for possible cracks in the tank.
Ask for a replacement if it is damaged.
Tighten the tank cap.
Check the tank cap for rubber ring,
contact us if any is missing.
Ensure the 1 spring is secured properly
to the tank allowing water to pass
through to the base.
1. Check if the room is too humid,adjust
to lower mist output.
2. Open door and windows, or change
to a larger room.
Humidi er should be placed on a hard
at surface, 2 feet above the oor, 12
inches away from the wall. Point mist
outlet away from wall or window.
Raise the room temperature to 25°C/77°F.
14