Axis Q8665–LEPTZ Guia De Instalacion página 26

AXIS Q8665–LE PTZ Network Camera
11. Using a RJ45 crimp tool, strip and crimp the network cable according to the
manufacturer's instructions.
12. Connect the network cable to the network connector on the base unit.
Note
To make the installation easier, it is possible to remove the power connector block from the
circuit board and mount it when the cables are correctly connected.
13. Connect the power cable to the power connector on the base unit. Make sure the
green/yellow ground wire is connected to the middle pin.
1
Network cable
2
Signal cables
3
Power cables
Note
The base unit can be attached to the bracket in four different positions.
Pos. 7
(-)
L
N
26
Pos. 8
(+)