Adjusting The Brightness; Adjusting The White Balance (White Point); About The Sensor Port - Silicon Graphics 1600SW Guia Del Propietario

Adjusting the Brightness

Brightness is adjusted by a software control panel. The way this
feature works differs between computers and adapter boards. See the
documentation that comes with the flat panel monitor's adapter board
or your computer's owner's guide for information on adjusting the
brightness.

Adjusting the White Balance (White Point)

Your flat panel monitor has a separate and unique system to set the
white point of your screen. As with the brightness adjustment, the
white point is adjusted through a software control panel, and the way
this feature works differs between computers and adapter boards. See
the documentation that comes with the flat panel monitor's adapter
board or your computer's owner's guide for information on setting
the white point.
Specifications for the adjustable white balance range are in "Technical
Specifications" on page EN-24.

About the Sensor Port

The flat panel monitor is equipped with a sensor port, which is a
3.5 mm (1/8 inch) jack located between and slightly below the power
connector and the interface cable. See Figure 1-1.
The sensor port can be used with light- and color-sensing devices
(such as a colorimeter), if your host computer supports the device. See
your owner's guide, the information provided with your adapter
board, or other documentation.
EN-10 Chapter 1