ELICA KIT0154387 Guía De Instalación, Uso Y Mantenimiento página 12

NOTE: For the Range Hood Models EVV636S1, EVV648S1,
EVI642S1, EVI648S1 follow the next
NOTE: For the Range Hood Models EVV636S1, EVV648S1,
EVI642S1, EVI648S1 use de 9 wire connector assembly and
the 15.9mm strain relief.
1 With the range hood mounted (see the range hood
installation instructions), locate the wiring cable connector
inside the range hood.
2 Disconnect the Hood Insert Blower Connector.
B
A. Hood Insert
Blower Connector
B. Hood Smart
3 Install the connector support bracket with screws
(2)4.2x8mm included in kit; put the hood blower
connector in the cavity of the bracket.
B
A. Hood Blower
Connector
B. Connector support
bracket
12
instructions.
A
A
4 Connect the 9-wire connector assembly supplied with
the in-line blower motor system to the mating connector
from the range hood.
B
A. Hood Insert
Blower Connector
B. 9 Wire Connector
5 Remove the screws and cover of the hood terminal box.
6 Remove the knockout from the top of the hood terminal
box .
A
7 Install UL listed or CSA approved strain reliefs. Run
through the strain reliefs the 9 wire connector
and the In-Line Blower wiring conduit (not incluided
leaving enough wire length to make the wiring
connections.
A
A. Terminal box cover
B. Knockout
B