Wiring Instructions - Skuttle Indoor Air Quality Products SK0-0055-001 Instrucciones Para La Instalación

Wiring Instructions

DANGER: Disconnect electrical power to the humidifier before
starting installation. Death or injury is possible if you come in
contact with a live wire.
NOTE: All electrical wiring should comply with local codes and
ordinances.
1. For specific wiring instructions, consult the instructions included
with the humidifier and any additional controls.
2. Use the wiring diagram on page 5 for a single-speed blower
operation only.
3. When wiring a multi-speed blower system, use an A50 relay
or a fan sail switch to prevent premature component failure.
4. When wiring a fan-powered flow-thru humidifier or a steam unit,
consult the unit's wiring diagram. These units do not require an
additional transformer.
FIGURE 2: Wall-Mount Wiring Diagram
3/8 in. (0.95 cm) Screws
Base Plate
Humidistat
Humidistat
Cover
Indicator Knob
Wire Terminals
Cover Label
4
3/8 in.
(0.95 cm)
Drill Hole
for Wires
1 in. (2.54 cm) Screws