Loading Your Wine Cooler - THERMEx Winemex69 Manual De Instalación

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

You may load your wine bottles in single or double rows while taking note of the following: if you do not
have enough bottles to fill your wine cooler, it is better to distribute the load throughout the wine cooler
so as to avoid "all on top" or "all below" type loads.
- Do remove or relocate adjustable wooden shelves to accommodate larger type of bottles or increase the
capacity of the cooler by stacking the bottles up when necessary. (See removing shelves)
- Keep smalls gap between the walls and the bottles to allow air circulation. Like an underground cooler
air circulation is important to prevent mould and for a better homogeneous temperature within the cooler.
− Do not over load your wine cooler to facilitate air circulation.
− Do not stack more than 1.5 rows of standard 0.75L bottles per shelves to facilitate air circulation
− Avoid obstructing the internal fans (located inside on the back panel of the wine cooler).
− Do not slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
− Do not pull out more than one loaded shelf at a time as this may cause the wine cooler to tilt forward.
− Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct air circulation.
− Do not move your wine cooler while it is loaded with wines. This might distort the body of the wine
cooler and cause back injury.

LOADING YOUR WINE COOLER

Tabla de contenido
loading

Este manual también es adecuado para:

Winemex24Winemex20Winemex40Winemex145

Tabla de contenido