THERMEx Winemex69 Manual De Instalación página 13

INSTALLATION INSTRUCTIONS FOR BUILT IN WINE COOLERS:
WINEMEX69 model is free standing only. Any built in voids the warranty
1. "Built in" wine coolers are front venting but are not designed to be fully integrated behind a joinery
door.
2. Please follow the installation diagram when installing built-in wine coolers. No less than the minimum
installation dimension, or it will affect the venting of cooler.
3. Built-in wine coolers draw air from right of ventilation frame (WINEMEX24 from the rear) and expel
through left of ventilation frame under the front door.
4. "Built in" wine coolers have a power switch located on the control panel so power point location is not
critical.
5. The wine cooler requires a standard 240 volt/10 amp power point. (Or according to different countries
specifications).
6. The power cord is 2.0m in length and is fixed on the right side at the back when looking from front of
cabinet.
7. As with most appliances of today, the wine cooler has sensitive electronic components which are
susceptible to damage through lightning and electricity supply faults. It is therefore advised to use a
power surge protector to avoid problems of this nature.
Air vent on door must be provided for built-in wine coolers when a wood door installed.
In Hot climate zone, an air vent or grid, with a minimum ventilation size of 200mm x 40mm MUST be
cut out at the rear top of the back partitioning or at the top of either side of the partitioning, allowing cool
fresh air full access to flow into the 30mm gap located at the rear of the cabinet.
This air vent or grid must not be opened on the same side as other appliances such as ovens or an area
that is sealed and without access to fresh cool air. Failing to comply with the above specifications could
result in WARRANTY void.
Note: The appliance must be positioned so that the plug is accessible after installed.
WINEMEX24 Installation Instruction:
It is built-in model inside cabinet, the cabinet should come with good ventilation space and no backplane,
otherwise it will affect the wine cooler working normally. (Installation drawing as below)