Installing Your Wine Cooler; Adjusting And Removing The Shelves - THERMEx Winemex69 Manual De Instalación

INSTALLING YOUR WINE COOLER

Unpack and remove all of the protection and adhesive strips from the packaging around and inside the
wine cooler.
The wine cooler must be positioned such that the plug is accessible. Release the power cord. Move your
wine cooler to its final location. The wine cooler should be installed in a suitable place where the
compressor will not be subject to physical contact.
Leveling your wine cooler: Wine cooler must be leveled BEFORE loading your wines.
Your wine cooler is equipped with 4 adjustable feet to facilitate easy leveling. We recommend that you
tighten the back feet to the maximum and adjust the front feet to level the wine cooler.

ADJUSTING AND REMOVING THE SHELVES

For easy access to the storage content, you must pull the shelves approximately 1/3 of its depth out of the
rail compartment. These wine cabinets, however, are designed with a notch on each side of the shelf
tracks to prevent bottles from falling.
When removing any of these shelves out of the rail compartment, tilt the shelf as per the diagram and
simply pull out, or push in the shelf until it sits on the support brackets securely.
Shelf installation and taking instruction:
Common wooden shelf:
Shelf taking: According to below instruction drawing to press one side of shelf limit pin①, extract and
mark ③.
remove the shelf from the other side of support bracket②, then take off the shelf following the arrow
Shelf installation will be opposite with shelf taking.
1、"A" is shelf limit pin
2、"B" is shelf
Shelf taking: According to below instruction drawing to pull out the shelf to support bracket ① , press
Sliding wooden shelf installation and taking instruction:
two sides of sliding roller buckles and pull out the shelf following the arrow mark ② .
of sliding roller following the arrow mark ③ .
Shelf installation: According to below instruction drawing to push in the shelf alignment with two sides