Bandsaw Is Not In Working Order; Bandsaw Is In Working Order; Manufacturer's Warranty - Hilti SB 4-A22 Manual De Instrucciones

7.1 Bandsaw is not in working order

Malfunction
No response from the LEDs.
1 LED flashes.
4 LEDs flash.

7.2 Bandsaw is in working order

Trouble or fault
The tool does not develop full
power.
8 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode
if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution. Careless disposal may permit unauthorized and improper use of the
equipment. This may result in serious personal injury, injury to third parties and pollution of the
environment.
▶ Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble
or incinerate the batteries.
▶ Batteries that have reached the end of their life must be disposed of in accordance with national
regulations or returned to Hilti.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.

9 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 12.06.2017 | Doc-Nr: PUB / 5310775 / 000 / 03
Possible cause
The battery is not correctly in-
serted.
The battery is empty.
Safety lock not pressed.
The battery is discharged.
The battery is too hot or too cold.
Bandsaw momentarily overloaded.
Bandsaw too hot.
Tool is blocked
Possible cause
The control switch is not fully
pressed.
The battery is discharged.
Action to be taken
▶ Push the battery in until it
engages with a double click.
▶ Charge the battery.
▶ Press the safety lock.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Release the control switch and
then press it again.
▶ Allow the bandsaw to cool
down.
▶ Check whether the saw blade is
fitted correctly and/or damaged.
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
English 9