Careful Handling And Use Of Batteries; Intended Use; Possible Misuse - Hilti SB 4-A22 Manual De Instrucciones

▶ Apply only moderate pressure and cut at an appropriate speed, especially when cutting large-diameter
pipes. This will help to prevent the power tool overheating.
▶ Before cutting through pipes, make sure that the pipes are empty, i.e. that they do not contain liquids.
Drain the pipes if necessary.
▶ When cutting through pipes, hold the power tool above the level of the pipe you are cutting through.
◁ The power tool incorporates no protective measures to prevent ingress of water or moisture. Liquids
running out of pipes may cause a short circuit in the power tool.
▶ Never cut into unknown materials and keep the line of cut above and below the workpiece free of
obstacles.
◁ If the saw blade strikes an object it may cause the power tool to kick back.
▶ Wear protective gloves also when changing the accessory tool. Touching the accessory tool presents a
risk of injury (cuts or burns).
▶ Always remove the battery when the power tool is not in use, before maintenance, before changing
accessory tools and before transport.
▶ Engage the transport lock before storing or transporting the power tool.
▶ Observe the manufacturer's instructions regarding the handling and storage of saw blades.

2.4 Careful handling and use of batteries

▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not take apart, squash or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not attempt to charge or continue to use damaged batteries.
▶ If the battery is too hot to touch, it may be defective. In this case, place the power tool in a non-flammable
location, well away from flammable materials, where it can be kept under observation and left to cool
down. Contact Hilti Service after the battery has cooled down.
3 Description
3.1 Product overview 1
Battery
@
Control switch safety lock (switch-on
;
interlock)
Control switch
=
Grip (insulated gripping surface)
%
Guide
&
Bandsaw blade
(
Direction-of-rotation arrow on casing
)
3.2 Product overview 2
Saw blade guard
|
Saw blade guard fastening screw
¡

3.3 Intended use

The product described is a cordless bandsaw. It is designed for cutting metals and plastics.
The product is designed for two-handed operation.
▶ Use only Hilti Li­ion batteries of the B 18 / B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series to charge these batteries.

3.4 Possible misuse

▶ Do not use the power tool to cut bricks, concrete, cellular concrete, natural stone or tiles.
▶ Do not use the product to cut pipes containing liquids.
▶ Do not saw into unknown materials.
4 English
Printed: 12.06.2017 | Doc-Nr: PUB / 5310775 / 000 / 03
Lever for tensioning bandsaw blade
+
Side handle (insulated gripping surface)
§
Battery release button
/
Battery state of charge indicator
:
Roller for bandsaw blade
∙
Blade guide
$
Rubber ring
£