Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The drain will stop automatically after 5 minutes (cycle
pushbutton is red).
N.B : the button turns off completely after about 15"
seconds.
To stop manually the drain cycle,
button "C" again.
Reinstall the overflow and close the hood.
WARNING!
operations the cycle pushbutton will be red colour and
will flash slowly, to indicate that the machine is still
powered by the mains.
Disconnect the machine from the mains power
supply by the wall-switch !
CLEANING
AND
MAINTENANCE
PRECAUTION
INSTRUCTIONS
WARNING!
-
cleaning
and
disconnect the equipment from the mains power
supply:
-
Follow the directions on the maitenance in this
guide;
-
Wear protective clothing and gloves when
challenged elements
are impregned with
solution;
-
High temperatures can be reached inside the
machine (90°C). After power supply has been removed,
wait until the machine has reached room temperature,
before working on it.
-
Never leave tools, parts or other loose material
in or on the machine;
-
Chek that there are no rusting foreign bodies,
because of the material "stainless steel" could begin to
rust. Rust particles can come from non- stainless steel
dishes or damaged wire baskets.
-
Do not wash the machine
surrounding it with fire hydrants, steam jets of high-
pressure cleaners;
-
When clearing the floor
saturate the base of the machine, in order to avoid a
prolonged stagnation of water;
-
To clean the inside of the machine, use a brush
or a soft cloth;
-
To clean the machine do not use abrasive
cleaners;
-
BEFORE starting machine or cycle, after any
maintenance or repair work, make sure all
protectives are correctly installed;
press the cycle
At the end of the drain
PREVENTIVE
AND
CLEANING
:
Before carrying out the
maintenance
operations,
clearing
and the area
be careful not to
DAILY CLEANING OF THE INTERIOR
OF THE DISHWASHER
-
Disconnect the machine by pressing the main
switch "A";
-
Remove the
water
drain out of the tank (look at the
specific paragraph at the preceding page);
-
Wait untill all water is drained and there are no
wastes
Once the emptying is completed, indicator "C"
will
automatically
15"seconds
-
Disconnect the machine from the supply mains
by the wall switch;
-
Take the filters out and clean them under
running
water;
-
Re-assemble the removed parts in their
housing;
-
Check and clean the washing and the rinsing
jets;
Daily disassemble the lower and upper wash
arms by working on the „big" ring nut,
like in the picture.
-
Clean the outer surface of the machine by
using a wet sponge; do not use water jets
because, besides being dangerous, they could
damage the electrical parts; do not use
abrasive detergents;
-
When the machine is to remain unused for a
long time, it's better to perform the operation
od descaling and sanification.
-
To avoid bad smells, leave the hood open.
WARNING
out cleaning the inside of the machine, make
sure that there are no foreign objects that could
damage the rusty steel inside the tank. The
eventual rust particles could come from non-
stainless steel dishes, from baskets or damaged
water pipes not rust-proof.
NEVER WASH THE EXTERNAL PART
THE MACHINE WITH A WATER JET
27
overflow
pipe and let the
on
the
tank
turn
off
after
. Before carrying
bottom;
about
OF
Tabla de contenido
