Belkin Wireless G Manual Del Usuario página 106

Print-Server Installation in
Windows 98SE/Me/NT
1
If the DHCP server is unavailable or not found, the user will be
prompted to configure the TCP/IP settings of the Print Server
2
manually. The default TCP/IP-address information in the Manual-IP
mode will be what is shown below.
3
IP Address:
4
Subnet Mask:
Default Gateway:
DNS:
5
Make sure that the TCP/IP information configured here is correct
6
and matches your network settings. Click "Next" to continue on to
next step in the installation process. The Print Server will check if
7 the manually configured IP address in "TCP/IP Configuration" is in
the same subnet as the connected computer running the installation
utility. If the TCP/IP-address settings configured manually are in a
8
different IP subnet than that of the connected computer, the user
will be prompted by an alert message. Click "OK" to go back and
configure the correct IP-address settings for the Print Server.
9
Note:
10
Server at some point after the installation, you can use the
Server-Manager utility's TCP/IP- configuration option.
11
11.
The default wireless setting is "Auto" mode. The Print Server
12
12
will detect a connection to a wired-L AN network through
the attached Ethernet cable. If the Print Server is connected
to a wired network, it will work in that network. To enable
13
13
wireless mode, the Ethernet cable must be disconnected
after final configurations. However, the Ethernet cable needs
14
14
to stay plugged in for the required wireless configurations
in this section. For more detailed information about wireless
settings, refer to the "Wireless Configuration" section.
15
15
16
16
17 17
192.168.2.253
255.255.255.0
192.168.2.1
0.0.0.0
If you want to change the TCP/IP settings of the Print
106