Emerson DL8000 Instrucciones Para Un Uso Seguro página 3

Emerson DL8000 Preset Controller
Use this safe use instructions (SUI) document with the
DL8000 Preset Controller Instruction Manual (part
D301244X012). For full cautions and descriptions of
installation and troubleshooting procedures, refer to this
manual. If you require training for this product, contact
your local sales office.
The DL8000 Preset Controller (or "DL8000") with CE
marking can be ordered with or without NMi approval or
with any of the optional communications or I/O modules
listed in the DL8000 Preset Product Data Sheet (part
D301255X012).
DANGER
When installing units in a hazardous area, make sure all
installation components selected are labeled for use in
such areas. Installation and maintenance must be
performed only when the area is known to be non-
hazardous. Installation or maintenance in a hazardous
area could result in personal injury or property damage.
Always turn off the power to the DL8000 before you
attempt any type of wiring. Wiring powered equipment
could result in personal injury or property damage.
To avoid circuit damage when working inside the unit, use
appropriate electrostatic discharge precautions, such as
wearing a grounded wrist strap.
Check the input power polarity before connecting power
to the DL8000. Wiring powered equipment could result in
personal injury or property damage.
Figure 1. DL8000 Label (with NMi Approval)
Declaration of Conformity (NMi Version)
Hereby, Remote Automation Solutions declares that the
DL8000 products are in compliance with the essential
requirements and other relevant provisions of European
Directives 2014/30/EU (EMC), 2014/34/EU (ATEX), and
2014/32/EU (MID).
Remote Automation Solutions
Safe Use Instructions – Emerson DL8000 Preset Controller
ATEX Special Conditions for Use
Use fasteners (bolts) with yield stress greater than 240
▪
N/mm².
MID Special Conditions for Use
The minimum measured quantity shall be inscribed on
▪
the calculating and indicating device or on a separate
plate in the direct vicinity of the display.
In installations where more than one measurement
▪
transducer is applied, an identification of the
connected measurement transducer shall also be
applied on or in the vicinity of the calculating and
indicating device.
In systems where volume conversion is carried out, a
▪
description of the reference condition is applied on or
in the vicinity of the display.
In case a printing device is connected, provide an
▪
additional feedback from the printing device to the
calculating and indicating device for power-off
detection and paper-out detection.
Specifications (NMi Version)
POWER
100 to 240 V ac (+10%/–15%), 50 to 60 Hz,
1-phase 30-watt nominal.
MATERIALS
Enclosure: IP66, weatherproof, corrosion-resistant
cast aluminum with stainless steel bolts.
Wire Channel Covers: Polypropylene Plastic.
Modules: Thermoplastic Polyester, solvent-
resistant.
ENVIRONMENTAL
Temperature (operating):
–40C to +65C.
–20C to +65C (LCD display).
–25C to +55C (certified by NMI).
Temperature (storage, non-operating):
–30C to +80C.
Relative Humidity: 5-95% non-condensing per IEC
60068-2-3.
WEIGHT
34 kg for housing, backplane, and CPU.
Part D301347X412
February 2018