Hisense FMN544I20S Manual De Instrucciones página 44

12
Note
： ： ： ：
The water lines must be fully inserted into
the filter to prevent water leaking.
The line length should be less than 5m. If
the water line is too long(>5m), the ice and
cold water content may be affected due to
insufficient water pressure.
Cut the water line as required length and
avoid overbending the water lines.
It is recommended to have a suitably
qualified person to install the product.
Warning!
The water filter must be held upright as
shown in the figure above. It is critical to
connect the water inlet and outlet hoses
on the filter correctly.
Never mount the
refrigerator. Coolant pipes might be
pierced.
Installing the water lines of the filter
To install the water lines of the filter,
follow the instructions of installing steps
below that referring to the figures supplied.
1. Take the 2 clips out, then pull out the 2
stopper of the water filter.
2. Fully insert the water lines into the Inlet
filter onto the
and Outlet of the water filter.
3. Insert the 2 clips in the proper position
as the figure shown below, and confirm
that each clip holds the water line firmly.
Connecting the filter inlet line to the
water supplier
The connector and the check valve is
provided as one part. You should use the
new connector incidentally but not the old
one you have.
Screw the adaptor onto a suitable 3/4"
BSP connector water outlet, and use the
spanner to tighten it. Fully insert the water
line into the check valve. Then insert the
clip in the install pack as the figure shown
below.
Note:
After installed the filter, please open the
water valve to flush the filter for 5 minutes
before use.